found at http://linuxpoison.blogspot.com/2009/02 ... ivity.html

Open terminal and fire following command
# cat /sys/block/sda/stat
186908 41568 6033917 2408504 91198 509600 4882200 9406764 0 1161304 11848624

Field 1 -- # of reads issued
This is the total number of reads completed successfully.

Field 2 -- # of reads merged, field 6 -- # of writes merged
Reads and writes which are adjacent to each other may be merged for efficiency. Thus two 4K reads may become one 8K read before it is ultimately handed to the disk, and so it will be counted (and queued) as only one I/O. This field lets you know how often this was done.

Field 3 -- # of sectors read
This is the total number of sectors read successfully.

Field 4 -- # of milliseconds spent reading
This is the total number of milliseconds spent by all reads (as measured from __make_request() to end_that_request_last()).

Field 5 -- # of writes completed
This is the total number of writes completed successfully.

Field 7 -- # of sectors written
This is the total number of sectors written successfully.

Field 8 -- # of milliseconds spent writing
This is the total number of milliseconds spent by all writes (as measured from __make_request() to end_that_request_last()).

Field 9 -- # of I/Os currently in progress
The only field that should go to zero. Incremented as requests are given to appropriate request_queue_t and decremented as they finish.

Field 10 -- # of milliseconds spent doing I/Os
This field is increases so long as field 9 is nonzero.

Field 11 -- weighted # of milliseconds spent doing I/Os
This field is incremented at each I/O start, I/O completion, I/O merge, or read of these stats by the number of I/Os in progress (field 9) times the number of milliseconds spent doing I/O since the last update of this field. This can provide an easy measure of both I/O completion time and the backlog that may be accumulating.

Note, this is device specific.